Flashing VU Solo BY USB

Flash VU Solo anda via USB
 
Format a usb flash drive to Fat32.
Format FD ke Fat32


1. On the USB stick create a folder and name it vuplus inside that folder create another folder and name it solo.
1. Pada FD buat sebuah folder dan namakan vuplus dan didalam folder tsb buat lagi folder lain lalu namai folder tsb solo.

2. Download the USB version of a image and unrar. Now send the boot, kernel and root file to the solo folder.
2. Donlot image versi USB dan unrar. Lalu kirim file boot, kernel dan root ke folder solo.

3. Insert your USB stick in the front USB port. Then on th rear of your solo press the reset button.
3. Colokkan FD pada port USB depan. Lalu tekan tombol reset yg terdapat di sisi bagian belakang solo.

When the VU Solo start the standby light will be RED. You should see the led light on your USB flashing. This shows the SOLO is reading the USB stick.
Ketika VU Solo memulai proses lampu standby akan bewarna MERAH. Lampu led pada USB akan menyala (berkedip). Ini menunjukan SOLO sedang membaca FD.

After a while you'll see the LED on your USB stop flashing. When this happens it means your SOLO is been programmed from it's internal memory after reading the USB drive.
Setelah beberapa saat Anda akan melihat LED pada USB anda berhenti berkedip. Ketika ini terjadi berarti SOLO anda telah menjalankan program dari memori internal setelah membaca drive USB.

When your Standby light turns green the flashing process is over and you can remove the USB stick.
Ketika lampu standby berubah hijau maka proses flashing selesai dan Anda dapat mencabut FD

Press the reset button on the rear again and the Solo will boot into the enigma2 setup process.
Tekan tombol reset pada bagian belakang lagi dan Solo akan boot ke proses setup Enigma2.

sumber @BP